Air Suspension A-2464 REV 5 User Manual
Page 4
4
A-
2464
ARNOTT FRONT RIGHT AIR SPRING
FOR
2000-2006
BMW X
5
REV 5
02/17/2014
A-2464
4.
REMOVE THE TWO (2) O-RINGS AND TWO (2) BACK-UP RINGS FROM THE TOP OF THE SHOCK SHAFT AND
DISCARD. (FIGURE E)
5.
INSTALL THE NEW ARNOTT® AIR SLEEVE ASSEMBLY ONTO SHOCK WITH THE ALIGNMENT PIN IN THE
SAME ORIENTATION AS THE OLD AIR SPRING. APPLY A SILICONE BASE LUBRICANT ON THE LOWER
O-RINGS PRIOR TO INSTALLING AIR SLEEVE ASSEMBLY. (FIGURE F)
6.
SLIDE AIR SLEEVE ASSEMBLY ONTO THE SHOCK UNTIL LOWER PISTON SEATS ONTO THE 2 (TWO) LOWER
O-RINGS. ALIGN THE HOLE IN THE ALIGNMENT TAB ON THE PISTON WITH THE HOLE ON THE SHOCK,
REINSTALL THE PLASTIC RETAINING PIN. FAILURE TO DO SO MAY CAUSE THE AIR SLEEVE ASSEMBLY TO
NOT SEAL OR INFLATE. (FIGURE G)
FIGURE E
FIGURE F
FIGURE G