Air Suspension A-2202 REV 2 - Manual (Page 2)

2
A- 2202
ARNOTT REAR AIR SPRING
FOR 1998-2004
LAND ROVER DISCOVERY II
A-2202 REV 2 01/17/2014
AIR SPRING REMOVAL
1. SET STEERING TO STRAIGHT AHEAD.
2.
RAISE VEHICLE.
3. REMOVE REAR WHEEL.
4. TO DEFLATE THE AIR SPRING, REMOVE THE AIR LINE BY PRESSING IN ON THE OUTER RING AND PULLING
OUT ON THE AIR LINE.
5. REMOVE THE 2 CLIPS SECURING THE TOP OF THE AIR SPRING TO CHASSIS.
6. COLLAPSE THE AIR SPRING.
7. ROTATE THE AIR SPRING TO UNLOCK IT FROM AXLE, AND REMOVE THE OLD AIR SPRING FROM THE VEHICLE.
GENERAL INFORMATION:
Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,
the full text of which is available at www.arnottinc.com.
• Not to be stored below 5
o
F (-15
o
C) and above 122
o
F (50
o
C).
• Avoid damage to air lines and cables.
• Removal and installation is only to be performed by fully qualified personnel.
• Use car manufacturer’s diagnostic software.
CAUTION: Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified
in the instructions or in a different sequence.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
Turn the air suspension switch to the OFF position (switch is located on the passenger front kick plate).