Armasight NSCCOMR00133DB1 CO-MR GEN 3 Bravo Day/night vision Clip-On system - Manual (Page 28)

28
4. To adjust the IR spot position in the field of view, loosen the clamp screw and tilt the IR850 as re-
quired in the spherical clamp hinge. Tighten the screw using a 2.5 mm hex key.
3.3.3 OPERATING IN CHANGING LIGHT CONDITIONS
If a mission must be carried out in changing light conditions, you can deactivate the bright light protec-
tion system of the CO-MR. To shut down the protection system, close the photoreceiver with the cap.
CAUTION:
After your mission is complete, open the photoreceiver by removing the cap.
3.3.4 SHUT-DOWN
Shut-down the CO-MR as follows:
1. Turn off the device. The green glow will disappear.
2. Place the cap over the objective lens.
3. Place the cap over the LED indicator.
4. Remove the CO-MR from the weapon/ day scope lens.
5. Remove the light suppressor from the output lens.
6. Screw the cap into the output lens thread.
7. Remove the IR850 from the CO-MR.
8. Remove the batteries.
CAUTION:
DO NOT store the equipment with the battery still in it.
CAUTION:
Remove the light suppressor from the CO-MR to avoid deformation or damage.
9. Ensure that the CO-MR and any accessories are clean and dry before placing them into the storage
case.
10. Place the CO-MR and any accessories into the storage case.
11. Store the CO-MR and accessories in the appropriate locations in the case and close the cover.