Armasight NSMSIRIUS1GMDA1 Sirius GEN 3 Ghost MG Multi-Purpose Night Vision Monocular - Manual (Page 25)

25
The transfer adapter can be adjusted for either the right or left eye. In Figure 3-9, the Sirius is shown in
the proper position for the left eye. Readjust the adapter for the right eye as follows:
— Push down on the lever (C). Remove the adapter from the Sirius rail.
— Loosen the nut (G), and turn the adapter around between the two fixing devices. Retighten the nut
(G).
— Mount the adapter to the other Sirius rail located on the opposite side of the unit.
3.1.10 MOUNTING ACCESSORY LENSES TO THE SIRIUS
To mount the 3X afocal lens (A) or 5X afocal lens (B) to the device, screw it into the threading of the
standard 1X objective lens on the Sirius.
To mount the 5X (C) or 8X (D) lens, unscrew the existing 1X objective lens of the Sirius and screw in the
3X, 5X or 8X lens in its place.
The Sirius configured with an 8X lens can be installed on a tripod. To mount the unit on a tripod, use the
1/4’’ threaded socket (E) on the housing of the 8X lens.
D B C
FIGURE 3-10. MOUNTING ACCESSORY LENSES TO SIRIUS
E
A
NOTE:
The unit may be badly damaged if the tripod collapses or overturns. Remove the unit from the
tripod if it is not within your reach.
3.1.11 MOUNTING THE SIRIUS TO A WEAPON WITH AN AIM
ADVANCED INTEGRATED MOUNT
The clamping system of the Advanced Integrated Mount (AIM) is the same as is seen on the QRM. To
mount the Sirius to a weapon with an AIM, see Part 3.1.5 of this Manual. This section details mounting
instructions and procedures for the QRM.
For more information on the use of an AIM, see the AIM PRO User’s Manual.
FIGURE 3-11. MOUNTING THE SIRIUS TO A WEAPON WITH AN AIM