Armasight NKMPRIME0511I11 Prime 5x GEN 1+ Night Vision Monocular - Manual (Page 7)

7
4. IR810 lOng RAngE IR IlluMInATOR (OPTIOnAl)
The IR810 is a removable infrared illuminator that can be installed on the rail of the night vision unit for
the purpose of enhancing the unit’s performance and long distance observation.
IR810 IlluMInATOR InSTAllATIOn
To install the IR illuminator on your Prime, perform the following:
1) Install the Dovetail to Weaver Transfer Piece on the rail
of your monocular.
2) Loosen the screw on the IR810 mount.
3) Place the IR810 on the Weaver rail.
4) Tighten the screw.
IR IlluMInATOR OPERATIOn
The Armasight IR810 runs on a single CR123A battery. To install the battery, unscrew the battery com-
partment cap and insert the battery in accordance with the unit’s polarity markings. Screw the battery
compartment cap back onto the device.
To turn the IR810 on, rotate its operation switch into the ON position.
Adjust the power of the beam emitted by the IR810. To change the brightness of the beam, rotate the
illuminator operation switch.
Focus the IR beam to change the field of coverage. To focus the beam, slightly rotate the IR illuminator
lens.
To adjust the IR spot position in the field of view, perform
the following:
1) Loosen the screw on the clamp of the IR illuminator
mount.
2) Turn on the sight and IR illuminator.
3) Carefully move the lens of IR810 up and down, as well as
side to side, and observe the IR spot position through the
eyepiece of the night vision weapon sight.
4) Tighten the screw of the clamp when the IR spot is fo-
cused in the center of the field of view.
5. MAInTEnAncE PROcEDuRES
The Prime should always be stored in the supplied packaging, particularly in heated and ventilated
rooms. To keep the device operational, please follow the instructions listed below regarding prepara-
tions for storage. The battery should be stored separately from the unit and be inserted into the battery
compartment only when the device is being prepared for use. The presence of both acids and alkalis’
near the monocular is not recommended.
When stored, your Prime should be protected from exposure to direct sunlight or extreme tempera-
tures.
MOnOculAR clEAnIng PROcEDuRES
1) Gently remove any dirt from the monocular’s body using a clean, soft cloth.
2) Wipe external surfaces down (with the exception of optical surfaces) with a clean cloth moistened
with pure water.
3) Dry all wet surfaces with a different clean, dry cloth.
4) Carefully remove any dirt from the optical surfaces using a lens brush.
focus AdjusTmenT
fixinG screw
BATTery compArTmenT
operATion swiTcH
screw of clAmp
BeAm direcTion
AdjusTmenT
doveTAil To weAver
TrAnsfer piece