Armasight TFT238MN6TS32RP FLIR Scout TS32R Pro 320x240 65mm monocular 8.3Hz, PAL - Manual (Page 14)

3—Operating Your Scout Camera Scout Operator’s Manual
10 June 2011
3–2 Installing the Batteries and SD Card
The batteries must be installed and charged before using your
camera. Also install your SD card at this time.
1. To aid in removal of the
battery cover, remove the
SD card door first. No tools
are needed.
2. Loosen the four captive
screws securing the battery
cover.
3. Remove the battery cover by
grasping the front edge, this
will be exposed when the SD
card door is removed.
4. Install the batteries as shown.
5. Install your SD card.
6. Snap the SD card door back into
place, ensuring that the rubber lanyard retracts into the camera.
7. Re-install the battery cover—it only fits one way.
8. Tighten the four screws.
If you have installed rechargable batteries, they must be charged
before using the camera. Regular AA batteries will provide about one
and a half hours of camera use.
Grasp SD card door edges and pull
Battery
cover
+
–
+
–
–
+
–
+
+
–
+
–
–
+
–
+