AVSL 160.028 UV CANNON - Manual (Page 2)

2/2
REPLACING LAMPS
1. Disconnect from main power supply before attempting to replace either lamp .
2. Ensure that the unit is sufficiently cool , before removing blown lamps.
3. Never touch new lamps with your fingers: use a tissue or a cloth.
In order to replace the lamp, disconnect from main power supply first, and unscrew the lamp replacement cover.
Only use the appropriately rated lamps as use of any other lamp type many cause the unit to be non-operational.
Due to the nature of halogen lamp it is vitally important that you do not touch the new replacement lamp with
your fingers, as this will reduce lamp life considerably. Once again a tissue or cloth can be used for fitting the
replacement lamp.
If after replacement of the lamp, the unit is still not working then please contact your dealer or our company for
servicing.
CLEANING
The most important part of your lighting effect to keep clean is the reflector as it allows the light output to
transmit. This should be cleaned with a soft damp cloth. The body of the unit may also be cleaned in the same
way . We recommend internal cleaning be carried out by a fully qualified technician.
MAINTENANCE & SERVICING
Work on internal parts should be carried out by a qualified technician. Removal of covers other than the front to
replace lamp is considered a breach of warranty and will not be covered under any such agreement unless
authorized first by the company.
TROUBLESHOOTING
• If the unit is not functional-check main power supply is ‘on’.
• If the unit is functional but lamp does not light-lamp may require replacing.
• If after trying this solution you still have a problem contact your dealer or our company for service.
CAUTION
Do not obstruct the air vents.
Do not touch unit or lamps while hot.
Never put any objects through the air grill on the top of the unit.
No user serviceable parts inside, please refer to our company.
POWER CONNECTIONS
The unit is supplied with a power plug appropriate to its voltage and destination. Should any other connections
be required they must be carried out with the following configuration.
Earth = Green/Yellow cable
Neutral = Blue cable
Live = Brown cable