Т³гж 10 – AVSL 154.093 DM-X16 User Manual
Page 10
Action : (
SCENE Review)
Action : (
SCENE Review)
2)
Select a SCENE button (1~8) to review.
1)
Select any one of the 30 banks by pressing the
BANK UP/DOWN buttons.
3)
Move wheel and faders to change fixture attributes.
Notes :
Notes :
Make sure you are still in MANUAL Mode.
3.3 Programming
3.3 Programming
A program (bank) is a sequence of different scenes (or steps) that will be called up one after another.
In the controller 30 programs can be created of 8 scenes in each.
3.3.2CREATE A SCENE :
3.3.2CREATE A SCENE :
1) Press the Program button until the LED blinks.
3.2.2
REVIEW SCENE OR CHASE
3.2.2
REVIEW SCENE OR CHASE
Action :
Action :
2)
you can position FADE and SPEED to any place
you need to achieve the effect you want to create.
1) Press the PROGRAM button until the LED blinks.
3)
Select the SCANNERS you wish to include in your
scene.
Notes :
Notes :
Deselect Blackout if LED is lit.
This instruction assumes that you have already recorded scenes and chases on the controller. Other
wise skip section and go to programming.
Action : (
CHASE Review
)
Action : (
CHASE Review
)
2)
Press the TAP DISPLAY button to view the step
number on the display.
1)
Press any one of the 6 CHASE buttons.
3)
Press the BANK UP/DOWN buttons review all scenes
in the chase.
3.3.1ENTERING PROGRAM MODE
3.3.1ENTERING PROGRAM MODE
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank memories on the
controller and each bank can hold 8 scene memories. The controller can save 240 scenes total.
4)
Compose a look by moving the sliders and wheel.
5)
Tap MIDI/ADD button.
6)
Choose a BANK (01~30) to change if necessary.
7)
Select a SCENES button to store.
8)
Repeat steps 3 through 7 as necessary. 8 scenes
can be recorded in a Program.
9)
To exit program mode, hold the PROGRAM button.
You can select more than one fixture.
There are 8 scenes available in every bank.
All LEDs will flash to confirm. The LED display will now
indicate the Scene number and Bank number used.
USER MANUAL
3.2 Operation
3.2 Operation
3.2.1 MANUAL MODE
3.2.1 MANUAL MODE
The manual mode allows direct control of all scanners. You are able to move them and change
attributes by using the channel faders.
Action :
Action :
2)
Select a SCANNER button.
1) Press the AUTO DEL button repeatedly until the
MANUAL LED is lit.
3)
Move faders to change fixture attributes.
Notes :
Notes :
All changes made while in Manual Mode are
temporary and will not be recorded.
TAPSYNC DISPLAY
button:
Press to toggle the output indicator on the LED display
between DMX values (0-255) and percentage (0-100)
9/18
DMX 512 CONTROLLER SERIES