Amplifier panel – AVSL 170.190 M8S User Manual
Page 2
170.190 User Manual
Introduction
Thank you for choosing the AV Link M8S active subwoofer as part of your sound system. This product is designed with
flexibility and reliability in mind to offer long-lasting, high quality output for many varied applications. Please read this
manual fully and follow the instructions to achieve the best results with your new purchase and to avoid damage through
misuse.
Warning
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on the cabinet, stop using immediately, allow unit to dry out and have checked by qualified personnel
before further use. Avoid impact, stress or extreme pressure to the cabinet
No user serviceable parts inside – Do not open the panel – refer all servicing to qualified service personnel
Safety
Check for correct mains voltage and condition of Fig.8 lead before connecting to power outlet
Ensure speaker wires and/or signal leads are in good condition with no shorts or damaged plugs
Do not allow any foreign objects to enter the case or through the ventilation grilles
Placement
Keep out of direct sunlight and away from heat sources
Avoid damp or dusty environments
Position on a level, stable surface, ideally against a wall or in a corner
Avoid sharp objects protruding through the front grille cloth or speaker cone
Ensure adequate access to controls and connections
Cleaning
Use a soft dry or slightly damp cloth to clean the cabinet as required
Use a vacuum cleaner to clear the rear heat-sink of any dust or debris build-ups
Do not use strong solvents for cleaning the unit
Amplifier Panel
1. Amplifier “HI LEVEL” inputs
Connect + and - wires between
amplifier L+R outputs and speakers
2. RCA L+R LINE IN
L+R inputs for line level audio signal
3. POWER LED
Indicates mains power on
4. FREQ control
Adjust cutoff frequency of crossover
5. VOLUME level control
Adjust overall output of subwoofer
6. Mains fuse holder
Replace only with approved type
7. Fig.8 Mains inlet
Connect supplied mains lead here
8. Power switch
Switches mains power ON/OFF
9. AUTO ON/ON
Select “Auto on” or “Always on”