C2G 26847 LANtest Pro 256652 - Manual (Page 3)

on model 256652/IDT)
Verification of shield integrity
Cross talk detection in excess of 3dB + 0.3dB at 3.5Mhz
between any two pairs
Specially designed remote unit that enables one person to
test installed cables
Easy to read fault display and high speed testing
Debug mode for detailed fault identification results
Auto sleep mode and power off switch to decrease power
consumption
LANtest Pro Specifications
Connectors
LANtest Pro Main Unit RJ45 jack
Remote Unit RJ45 jack
Pairs tested
1/2, 3/6, 4/5, 7/8 and shield
LED display
Horizontal: 5 Green LEDs for pair and shield display
(1-2, 3-6, 4-5, 7-8 and shield)
TONE G. LED (for models 256652/LBT, 256652/TK,
256652/TFK and 256652/IDT)
Vertical: 5 Red LEDs for fault display and #ID display
(OPEN, SHORT, REVERSED, MISWIRE,
SPLIT PAIRS and LOW BATTERY)
For 256652/IDT the fault display shares with the #ID
Display (#1, #2, #3, #4)
Cable test length limit
Minimum: 0.4m Maximum: Over 200m
Power:
LANtest Pro: 6V alkaline DC battery
Remote identifier: No battery required
Dimensions:
LANtest Pro: 125 x 52 x 30 mm (L x W x H)
Low battery indicator
LANtest Pro Cable Test Operation:
1.Select "Cable" position on the toggle switch.
2.Plug one end of the subject cable into the RJ45 jack on
the master unit and the other end into the RJ45 jack on
the remote terminator.
Note: The remote terminator can be slipped and locked into the
master unit for convenient testing of patch cables.
3.Push the test button and check the results: First, check
the 5 horizontally aligned green LED indicators (1-2, 3-
6, 4-5, 7-8, SHIELD) for integrity status:
Solid light : pair is OK
Flashing light : pair is faulty
No light : open pair
a. Simultaneously, check the 5 vertically aligned LED
indicators (SHORT, REVERSED, MISWIRE, SPLIT
PAIRS) for the wiring faults.
b. For more detailed information about what faults are
occurring in which pairs, hold the TEST button for 2
seconds to activate "Debug mode." The tester will test
each pair one by one, pausing briefly on each pair, and
display the corresponding fault status.
LANtest Pro Tone Generator Operation (only
available on models 256652/LBT, 256652/TK,
256652/TFK and 256652/IDT):
1. Slide the toggle switch on the LANtest Pro to the "Tone"
position
2. Quickly press the TEST button once for continuous tone
mode, or hold down for two full seconds for warble tone
2 3