C2G 39977 USB 2.0 EASY TRANSFER CABLE FOR WINDOWS - Manual (Page 34)

33
To begin using PCLinq3, please follow the steps below.
Step 1
Plug the USB 2.0 Easy Transfer Cable for Windows in both PCs.
Step 2
Wait for Windows to detect the cable on both PCs and make sure the cable is properly installed (please
refer to Step 8 in the PCLinq3 Software Installation section of the user guide for reference on checking for
proper installation).
Note: After installing the PCLinq3 program for the first time, you have to plug the transfer cable in and
wait for the WET pop-up window before you can open the PCLinq3 program. Click “Cancel” to exit this
window.
Step 3
Go to the Windows Start menu, then Programs
ÆPCLinq3 to access the PCLinq3 programs. It is
important that you use the same program mode for each PC. If you are using ANSI mode for example,
both PCs should be running the ANSI mode program. Check the Status LED on the bottom right of the
program dialog box which indicates if it is ready or not. A green LED indicates a ready status, and a red
LED means that it is not ready or connection was not found. Make sure that the program shows two
green LEDs to verify a linked connection.
U
SING THE
PCL
INQ
3 P
ROGRAM