C2G 40430 Remote Control Repeater - Manual (Page 4)

Features:
• CFL friendly
This unit can be installed in an area with compact fluorescent lighting, and will work in
most lighting environments
• IR LED
Blue IR LED confirms the signal is being transmitted
• Wide Band IR
Wide Band IR receives infrared signal from many types of remotes
• Compact size
With the small size of the connecting block, you can mount it near audio equipment with
nearly no visibility
Connecting the Remote Control Repeater
Note: Careful consideration must be used when placing the IR Receiver near a Plasma Display.
Plasma Displays emit IR frequencies during use and may cause interference.
1. Take the Mini Stick IR Receiver and connect it to the IR Receiver input on the IR Connecting
Block.
2. Connect the emitters (up to six) to the emitter jacks labeled 1-6 on the IR Connecting Block.
3. Place the emitters on the source equipment.
4. Connect the 12VDC Power Supply to the Power jack on the IR Connecting Block and plug the
Power Supply in the wall outlet. The LED will illuminate with a red light letting you know power is
connected. If you are using a switched power outlet on a stereo receiver, connect the 12VDC
Power Supply to the Status jack on the IR Connecting Block. This will illuminate with a green
light indicating power.
Note: When an IR signal is received, the IR confirmation blue LED will flash.
1