Braun cruZer6 beard&head - Manual (Page 8)

9
Pilot light (5)
The pilot light shows the status of the batteries
Model cruZer6 beard&head:
• The pilot light blinks green when the appliance is being charged. When the
battery is fully charged, the pilot light shines permanently green provided
the appliance is connected to an electrical outlet.
• During cordless use the pilot light blinks green.
• The pilot light flashes red when the battery is running low. You should be
able to finish your current trimming sequence.
Model cruZer5 beard&head:
• The pilot light shines permanently green provided the appliance is
connected to an electrical outlet.
Comb attachments
(1a, 1b)
• The combs can be taken off by pressing the release buttons (1c) with your
thumb and forefinger.
• Note, the combs can only be taken off, when the precision trimmer (3) is
not extended.
Beard trimming
• Place the beard comb (1a) on the appliance with the appliance turned off
(a).
• Press length selector (6) and slide the beard comb up to your desired
beard length (possible length settings: 1, 3, 5, 7, 9, 11mm).
• It is advisable to begin with the highest setting and then reduce the setting
until you reach the desired beard length.
• Press the on/off switch. Hold the beard comb with the angled edge
against your beard and guide the trimmer against the direction of the hair
growth (a).
• To avoid clogging the beard comb with hair, clean it from time to time with
the brush.
Contour Trimming / Styling
• The wide trimmer (2) evenly cuts and trims large areas. It is ideal for
shaping sideburns, moustaches and partial short beards. Take off the
comb. While stretching the skin, guide the wide trimmer against the
direction of hair growth (b).
• The precision trimmer (3) (model cruZer6 beard&head only) precisely
defines lines and edges, being ideal for precise contouring. To use the
precision trimmer, press the release button (4) and slide it up (c).
99748123_beard-head_NA_S6-36.indd 9 99748123_beard-head_NA_S6-36.indd 9 18.01.11 10:27 18.01.11 10:27