Miele S8 UniQ - Manual (Page 35)

Use
Unwinding the cable (dia. 14)
^ Pull the mains cable out to the
required length (max. approx. 7.5 m).
^ Insert the plug in the socket correctly
and switch on.
The parking system lighting on both
sides switches on.
The first time the vacuum cleaner is
used, the lighting switches on after
approx. two minutes.
,
Warning: If vacuuming for longer
than 30 minutes, the mains cable
must be pulled out to its fullest
extent. Otherwise there is a danger
of overheating and damage.
Rewinding the cable (dia. 15)
^ Switch the vacuum cleaner off at the
wall socket and unplug it.
After approx. 30 seconds the parking
system lighting switches off again.
^ Press the rewind foot switch briefly.
The cable will rewind automatically.
Switching on and off (dia. 16)
^ Press the On/Off foot control s.
Regulating the suction
The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to
manoeuvre the floorhead.
Some models also have symbols on the
controls. The symbols indicate the type
of use the settings are suitable for.
The setting selected will light up yellow.
# - curtains, lightweight fabrics
$ - upholstery, cushions
% - thick pile carpets, rugs and
runners
Auto = suction power is automatically
adjusted for the type of floor
being vacuumed
,
Do not use the "Auto" setting to
vacuum lightweight materials or
curtains. These could be sucked in
and possibly damaged.
* - for daily energy-saving vacuuming
(this setting is also very quiet)
( - loop-pile carpets
) - hard flooring and for intensive
cleaning of carpets
,
When using the AirTeQ
floorhead, if the suction seems too
high, reduce the suction until the
floorhead is easier to manouevre.
Foot controls (dia. 17 + 18)
The first time the vacuum cleaner is
switched on, the "Auto" power setting
will be selected automatically.
^ Press the + foot control to select a
higher setting.
^ Press the - foot control to select a
lower setting.
en
35