Braun 3105-5449 InterFace Excel - Manual (Page 7)

7
3 Keeping your shaver in top shape
3.1 Cleaning
• After shaving, switch the shaver off. Press the release buttons, take off
the shaver foil (d) and gently tap it out on a flat surface (e).
• Then thoroughly clean the cutter block with the brush (f).
• Do not clean the shaver foil with the brush.
• If you have a very dry skin and you notice a reduced operation time of
the shaver, you should put a drop of light machine oil onto the InterFace
trimmer and shaver foil (g).
3.2 Replacing the shaving parts
• To maintain 100% shaving performance, replace your foil and cutter
block every 18 months or when worn. Change both parts at the same
time for a closer shave with less skin irritation.
(Shaver foil and cutter block: part no. 3600)
• Press the release buttons, take off the shaver foil. Replace the new
shaver foil in the right direction until it locks in place.
• To remove the cutter block, lift it off (g).
• To replace the cutter block, snap onto the holding studs.
Subject to change without notice.
5449300_3105_NA Seite 7 Dienstag, 18. Oktober 2005 8:54 08