Document Outline

• Notices
  • FCC notice
  • Important safety instructions
  • Laser compliance statement
  • Lithium battery statement
• 1 Getting started
  • Overview
    • Processor
    • Memory
    • System chipsets
    • Expansion slots
    • Hardware management support
  • Features summary
  • Preinstallation requirements
    • Selecting a site
    • Checking the package contents
  • Basic connections
    • Connecting the keyboard
    • Connecting the mouse
    • Connecting the VGA monitor
    • Connecting to the network
    • Connecting the power cable
  • System startup
  • Power-on problems
  • Connecting options
    • Printer
    • USB devices
  • Tower-to-rack option
• 2 System tour
  • External and internal structure
    • Front panel
    • Rear panel
    • Internal components
  • System board layout
    • Control Panel (JP3)
    • Jumper Setting (J13)
    • Diagnostics LED (Port80LED)
• 3 Upgrading your system
  • Installation precautions
    • ESD precautions
    • Preinstallation instructions
    • Post-installation instructions
  • Opening your system
    • Removing the front panel
    • Removing the side panels
  • Installing and removing storage devices
    • Replacing a 3.5-inch or a 5.25-inch storage device
    • Installing a hard disk
    • Installing a DLT
  • Installing and removing the CPU
    • Installing a CPU
    • Removing a CPU
  • Installing and removing memory modules
    • Reconfiguring the system
  • Installing expansion cards
• 4 Setup utility
  • Introduction
  • Setup Menu
  • Setup submenu: Main
  • Setup submenu: Advanced
    • SuperIO Configuration
    • IDE Configuration
    • Floppy Configuration
    • OnBoard Devices Configuration
    • PCIPnP Configuration
    • Boot Settings Configuration
    • Event Log Configuration
    • System Health Monitoring Hardware
    • Remote Access Configuration
  • Setup submenu: Power
  • Setup submenu: Boot
    • Boot Device Priority
    • Hard Disk Drives
    • Removable Devices
    • ATAPI CDROM Drives
  • Setup submenu: Security
  • Setup submenu: Exit
    • Auto Configuration with Optimal Settings
    • Auto Configuration with Fail-Safe Settings
• 5 Configuring IDE Software RAID
  • Configuring Arrays
    • Configuration Strategies
    • Assigning RAID Levels
  • Selecting a RAID Level
  • Configuring Arrays
  • Using the IDE Software RAID Setup Utility
    • Auto Configure Stripe (F1)
    • Auto Configure Mirror (F2)
    • Auto Configure RAID 10 (F3)
    • Create Array (F4)
    • Delete Array (F5)
    • Restore Old Configuration (F6)
    • Save and Exit (F10)
    • Installing Windows NT 4.0 and Windows 2000 Drivers
    • Updating the Windows NT 4.0 or Windows 2000 Driver
    • Confirming the Windows NT 4.0 or Windows 2000 Driver Installation
  • IDE Software RAID Configuration Console Installation
    • Supported Internet Browsers
    • Installation Steps for Windows
    • Using IDE Software RAID Configuration Console
    • Config View
    • RAID Controller Properties
    • Property Description
    • Physical Drive
    • Array
    • Log Data
    • Advanced
    • Backplane
    • Close Server
• Appendix A: AMIBIOS POST Checkpoint Codes
  • AMIBIOS POST Checkpoint Codes
    • POST Checkpoint Codes
    • Bus Checkpoint Codes
• Appendix B: ASM quick installation guide
  • Installing ASM
    • System requirements
    • System setup
  • System rack installation
  • Vertical mounting hole pattern
  • Screw types for rack installation
    • Installing cage nuts
  • Installing the system into the rack
• Appendix C: Rack installation guide