Xylem IM245 RGS2012E1 S or E Retrofit Kit SUBMERSIBLE GRINDER PUMP - Manual (Page 2)

2
PUMP INSTALLATION
Grinder pumps should be installed in a basin that
is vented per the local plumbing code in your area.
The pump is not to be installed in locations that are
hazardous in accordance with the NEC. All plumbing
should be beneath the frost line for the region station
is installed in to ensure that pipes do not freeze.
Never lift the pump by the cord. Use
the lifting rope provided with the retro-
fit kit for lifting.
OLD PUMP REMOVAL
1. Supply power must be turned off
2. Goulds Water Technology recommendation is to
use a 20 amp circuit breaker. Check the existing
panel for breaker size and replace if necessary.
3. Remove the basin cover from the current station
4. If basin is full of water, pump water out with sepa-
rate pump or vacuum truck. Discard waste in ac-
cordance with local, state and national codes.
5. Disconnect quick disconnect.
SAFETY INSTRUCTIONS
TO AVOID SERIOUS OR FATAL PERSONAL INJURY
OR MAJOR PROPERTY DAMAGE, READ AND
FOLLOW ALL SAFETY INSTRUCTIONS IN MANUAL
AND ON EQUIPMENT.
THIS MANUAL IS INTENDED TO ASSIST IN THE
INSTALLATION AND OPERATION OF THIS UNIT
AND MUST BE KEPT WITH THE UNIT.
This is a SAFETY ALERT SYMBOL.
When you see this symbol on the
pump, the controller or in the
manual, look for one of the follow-
ing signal words and be alert to
the potential for personal injury or
property damage.
Indicates an imminently hazardous
situation which, if not avoided, will
result in death or serious injury.
Indicates a potentially hazardous
situation which, if not avoided, could
result in death or serious injury.
Indicates a potentially hazardous
situation which, if not avoided, may
result in minor or moderate injury.
NOTE: INDICATES SPECIAL INSTRUCTIONS
WHICH ARE VERY IMPORTANT AND
MUST BE FOLLOWED.
THOROUGHLY REVIEW ALL INSTRUCTIONS
AND WARNINGS PRIOR TO PERFORMING ANY
WORK ON THIS CONTROLLER.
MAINTAIN ALL SAFETY DECALS.
ALL OPERATING INSTRUCTIONS MUST BE
READ, UNDERSTOOD, AND FOLLOWED BY THE
OPERATING PERSONNEL. GOULDS WATER
TECHNOLOGY ACCEPTS NO LIABILITY FOR
DAMAGES OR OPERATING DISORDERS WHICH
ARE THE RESULT OF NON-COMPLIANCE WITH
THE OPERATING INSTRUCTIONS.
1. This manual is intended to assist in the installation,
operation and repair of the system and must be
kept with the system.
2. Installation and maintenance MUST be performed
by properly trained and qualified personnel.
3. Review all instructions and warnings prior to per-
forming any work on the system.
4. Any safety decals MUST be left on the pump.
5. The system MUST be disconnected from the main
power supply before attempting any operation or
maintenance on the electrical or mechanical part of
the system. Failure to disconnect electrical power
before attempting any operation or maintenance
can result in electrical shock, burns or death.
DANGER
WARNING
CAUTION
CAUTION