YSI 650 MDS - Manual (Page 25)

YSI Incorporated 25 650 MDS
SECTION 4 SONDE MENU INTERFACE
4.1 INTRODUCTION
The Sonde menu selection in the 650 Main menu provides a terminal-like interface simulating the
connection of the sonde to a PC as described in detail in Section 2 of the 6-series manual. Thus, this item
provides access to the entire menu structure of your 6-series sonde software so that you can perform custom
setup in the same way that would be possible if the sonde were attached to a PC.
From the 650 Main Menu, select Sonde menu and press Enter. A display similar (depending on sonde
type and sonde software version) to that shown below will appear:
Note that the icon in the lower right of the screen has changed from “meter” to “sonde” indicating that the
menu shown originates in the 6-series sonde. Note also that the 650 display has been designed to be very
similar to that presented on a monitor when a 6-series sonde is attached to a PC as shown below.
------------------Main-----------------
1-Run 5-System
2-Calibrate 6-Report
3-File 7-Sensor
4-Status 8-Advanced
Select option (0 for previous menu):
Sonde Icon