Extron Electronics DVI DA Plus Series User Guide - Manual (Page 9)

Installation
This section describes:
• Installation Overview
• Rear Panel Features
Installation Overview
All three distribution amplifiers can be mounted on tabletops, under furniture, and in racks
by following these steps:
1. Ensure that the input sources, the distribution amplifier and the output displays are all
turned off and all power sources and signal cables are disconnected.
2. Mount the unit as described in “Mounting” on page 15 .
3. Connect the cables ( see “Rear Panel Features” on page 4 ).
4. If required, configure the internal DIP switches to disable EDID (see page 8) from
certain outputs or to activate the EDID Lock mode (see page 10).
5. Plug in the power supply (see page 4).
6. Turn on the display devices.
7. Turn on the input devices (see “ Operation ” on page 7).
DVI DA Plus Series • Installation 3