Extron Electronics DVS 605 User Guide - Manual (Page 23)

Input Configuration
This menu allows the user to adjust various input configuration settings such as video
signal type, film mode, horizontal and vertical start position, horizontal and vertical active
pixels, total pixel number, phase, and EDID settings for the selected input. The selected
input is shown as (x) on the LCD screen images.
INPUT
CONFIG
Rotate either to
select input
signal type.
INPUT #x
RGB
(x)FILM MODE
OFF
Rotate either to
turn film mode
off or to Auto.
(x)TPIX PHAS
1344* 01
Rotate to adjust
total pixels.
Rotate to adjust
phase (* = default).
INx EDID
1600x1200@60
Rotate to set
EDID resolution for
the active input.
Rotate to set
refresh rate.
Next (x)H START V
027 029
Rotate to adjust
horizontal start position.
Rotate to adjust
vertical start position.
(x)H ACT V
1024* *0768
Rotate to adjust
horizontal active pixels.
Rotate to adjust
vertical active pixels
(* = default).
Next
Next
Next
Next Next
Next
Figure 13. Input Configuration Menu
NOTE: Only inputs 1 and 2 offer selectable video types.
Input video types
Rotate either the Adjust horizontal ([) or Adjust vertical ({) knob while in any of the Input
submenus to select the appropriate video format.
Input 1
Input 1 is a universal analog input for RGB scaled, Auto YUV, RGBcvS, S‑video and
composite video.
When input 1 is set to YUV Auto, the scaler detects if YUVi or YUVp/HDTV is applied and
sets the input accordingly.
It can also be set to autodetect the incoming input signal type. This is the default setting.
Input 2
Input 2 is a universal analog input for RGB scaled, Auto YUV, RGBcvS, S‑video and
composite video.
When input 2 is set to YUV Auto, the scaler detects if YUVi or YUVp/HDTV is applied and
sets the input accordingly.
It can also be set to autodetect the incoming input signal type. This is the default setting.
Inputs 3-5
Input 3 through 5 are digital inputs for HDMI or DVI input signals.
DVS 605 • Operation 17