Installation and operation, Rear panel connections – Extron Electronics FOX SW8 User Guide User Manual

Page 10

Advertising
background image

FOX SW8 • Installation and Operation

4

Installation and

Operation

The topics covered in this section are:

•

Rear Panel Connections

•

Front Panel Configuration Port

•

Controls, Indicators, and Operation

Rear Panel Connections

100-240V 0.3A

50/60 Hz

RS-232

Tx Rx

FOX SW8

OPTICAL INPUTS

LOOP IN

LOOP IN

LOOP IN

LOOP IN

LOOP IN

LOOP IN

LOOP IN

OUT IN

1

2

3

4

5

6

7

8

5

1

3

4

2

3

3

2

3

3

2

3

3

2

2

2

2

2

Figure 2.

FOX SW8 Connectors

WARNING: Risk of serious physical injury: The FOX SW8 outputs continuous

invisible light, which may be harmful to the eyes; use with caution.

•

Do not look into the rear panel fiber optic cable connectors or into the fiber optic
cables themselves.

•

Plug the attached dust caps into the optical transceivers when the fiber cable is
unplugged.

NOTES:

•

Singlemode and multimode devices are not interchangeable. Ensure that the
connected transmitting and receiving devices are compatible with the FOX SW8.

•

Ensure that you use the proper fiber cable for your system. Typically, singlemode
fiber has a yellow jacket and multimode cable has an orange or aqua jacket.

•

In this guide, the term “sending connector” refers to an LC connector on a device
that outputs a fiber optic signal. The term “receiving connector” refers to an LC
connector that receives an optical signal.

a

AC power connector — Plug a standard IEC power cord into this connector to
connect the FOX SW8 to a 100 VAC to 240 VAC, 50-60 Hz power source.

Advertising