Extron Electronics FOXBOX SR HDMI User Guide User Manual
Page 40
2.
If you have not previously updated firmware for the FOXBOX unit, on the Add Device
screen (see figure 30), select the
RS-232
tab.
Figure 30.
Add Device Screen
If you have previously updated firmware for this model, click
Cancel
. The Firmware
Loader window appears. Proceed to step 5.
NOTE: The receiver does not have an Ethernet port. Do not select
TCP/IP
.
3.
From the drop-down menus on the RS-232 screen, select the appropriate Com port
number and baud rate (the default is 9600).
4.
Click
OK
. The Firmware Loader window appears (see figure 313).
5
Figure 31.
Extron Firmware Loader Window
5.
Select the FOXBOX receiver and click
File
>
Open
. The Choose Firmware File screen
appears (see figure 32).
6
6
Figure 32.
Choose Firmware File Window
FOXBOX SR HDMI • Remote Control
34