Extron Electronics FLS 101 User Guide - Manual (Page 26)

Reference
Material
This section provides technical specifications, included and replacement part numbers, and
optional accessories.
• Specifications
• Included Accessories
Specifications
NOTE: These devices are class 1 laser products. They meet the safety regulations of IEC-60825,
FDA 21 CFR 1040.10, and FDA 21 CFR 1040.11.
Optical specifications — FLS 101 fiber optic output
Number/type
Singlemode ............................. 1 laser emitter
Multimode ............................... 1 LED emitter
Connectors .................................... 2 connectors with LC, SC FC, and ST adapters
Wavelengths
Singlemode ............................. 1310 nm ±20 nm, 1550 nm ±20 nm
Multimode ............................... 850 nm ±30 nm, 1310 nm -10/+50 nm
Spectral width
Singlemode ............................. 5 nm (max.) at 1310 nm and at 1550 nm
Multimode ............................... 40 nm (typical) at 850 nm
120 nm (typical) at 1310 nm
Transmission power
Singlemode ............................. 0 dBm, 9 μm
Multimode ............................... -20 dBm, 62.5 μm
NOTE: Power will be 3 dB lower if a 50 μm mandrel-wrapped jumper is used instead of a 62.5 μm mandrel-
wrapped jumper.
Stability
Singlemode ............................. ±0.05 dB over 1 hour after 15 minute warmup
±0.1 dB over 8 hours after 15 minute warmup
Multimode ............................... ±0.1 dB over 8 hours after 5 minute warmup
Optical specifications— FPM 101
Wavelengths .................................. 850 nm, 1300 nm, 1310 nm, 1490 nm, 1550 nm; calibrated
Detector type ................................. Germanium (Ge)
Units of measurement .................... dB, dBm, μW
Fiber Optic Test Meters • Reference 20