Extron Electronics EWB 1000 - Manual (Page 2)

EWB 1000 • Installation Guide (Continued)
Extron USA - West
Headquarters
+800.633.9876
Inside USA and
Canada Only
+1.714.491.1500
+1.714.491.1517 FA
X
Extron USA - East
+800.633.9876
Inside USA and
Canada Only
+1.919.863.1794
+1.919.863.1797
FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656
FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566
FAX
Extron Middle East
+971.4.2991800
+971.4.2991880
FAX
© 2011 Extron Electronics All rights reserved. www.extron.com
Mounting the EWB 1000
1. Decide where to mount the EWB 1000. If
mounting to standard wood wall studs, locate the
center of the studs.
2. Place the EWB 1000 against the wall at the
mounting location. Use a level to ensure the box
is horizontal and mark the position of the four
holes.
3. If required, drill four holes into the wall.
4. Insert four screws (see the table on the previous
page) and attach the EWB 1000 to the wall.
5. Remove the required knockout and run conduit
or raceway to the EWB 1000.
6. Run cables through the conduit and the EWB 1000 knockout.
Mounting the TLP 1000MV
1. Remove the faceplate from
the TouchLink panel.
2. Attach the cables to the
back of the TLP 1000MV
(see the TLP 1000MV and
TLP 1000TV User Guide).
3. Secure the TLP 1000MV to
the EWB 10000 using the
four 6-32 screws provided.
4. Configure the TouchPanel as
described in the TLP 1000MV
and TLP 1000TV User Guide.
5. Snap the faceplate into
position (four clips on each
side).
68-2096-01
Rev. A 04 11
Mounting
Screws (4)
4
3
5
2