Extron Electronics MTP Series User Guide - Manual (Page 10)

MTP Series • Installation 4
Setting the Jumpers on Non AAP Models
1. Remove and retain the four screws (two on each side of the unit) that secure the cover
to the MTP (see
figure 1 ).
SHARP GAIN
Figure 1. Removing the MTP Cover
2. For the receiver, slide the cover slightly forward to clear the front panel adjustment
knobs.
3. Lift the cover straight up.
4. If the transmitter or receiver is an audio unit, remove and retain the two screws
that secure the audio board to the main (video) board (see
figure 2 ). Pull the audio
board back until the audio connectors clear the back of the unit and lift the board out of
the way.
NOTE: This step (4) and figure 2 are correct for either S-video or composite video
models.
Transmitter Front Panel Receiver Front Panel
Receiver Rear Panel Transmitter Rear Panel
Remove these screws.
Figure 2. Removing the Audio Board