Extron Electronics MTP 15HD RS Series User Guide Rev. C - Manual (Page 12)

Front Panel Features
See figure 2 and the following descriptions to identify the front panel features on the
transmitter and receiver.
MTP RL 15HD RS receiver
MTP T 15HD RS transmitter
MTP RL 15HD RS SEQ receiver
RGB
PEAKING LEVEL
RGB
DELAY
PEAKING LEVEL
MTP SERIES
RED
GREEN
ADJUST
BLUE
SELECT
50 Hz
RECORD
60 Hz SPARE
EDID
SELECT
ON
MTP SERIES
MTP SERIES
ON
1 2 3 4 5
H SYNC + V SYNC + S VIDE
O
END UNI
T
BI-232
ON
1 2 3 4 5
H SYNC + V SYNC + S VIDE
O
END UNI
T
BI-232
A
K
A
G F
A
H I J F G K
E D BC
Figure 2. MTP Front Panels
A Power LED — The LED indicator lights when the unit is receiving power.
B Record LED — The LED indicator flashes red during the EDID recording process to
indicate a new EDID being written to memory. The LED returns to a solid green after the
write completes.
C Record button — The recessed record button initiates recording of the EDID of a
display device (connected to the loop-through output) to user-programmable memory
position 0 on the rotary switch (
E ).
D Vertical frequency DIP switch — The first DIP switch selects the vertical frequency
for the pre-programmed EDID. When switched to Off (default position), the EDID
selected by the rotary positions 1 through E are based on 60 Hz. When switched to On,
they are based on 50 Hz. The second DIP switch, marked Spare, is not used.
NOTE: When the EDID select rotary switch ( E ) is in position 0 or F, the setting of
the first DIP switch is not applicable because the user-recorded or attached display
EDID is being used.
A Power LED
B Record LED
C Record button
D Vertical frequency DIP switch
E EDID select rotary switch
F Level control
G Peaking control
H Select button (SEQ model only)
I Red, Green, and Blue LEDs
(SEQ model only)
J Delay (skew adjustment) control
(SEQ model only)
K DIP switches (RL receivers only)
MTP 15HD RS Series • Installation and Operation 6