Extron Electronics MTP 15HD A Series User Guide Rev. F User Manual
Page 15
e
Mono audio output connector — Insert a 3.5 mm, 5-pole captive screw audio
connector into this connector for two mono audio outputs. Wire the connector as
shown in figure 7. Use the supplied tie-wrap to strap the audio cable to the extended
tail of the connector.
MONO A
UDIO
MONO A
UDIO
Do not tin the wires!
Balanced Audio Output
Tip
Ring
Tip
Ring
LR
Sleeves
Unbalanced Audio Output
Tip
Tip
LR
Sleeves
Figure 7.
Captive Screw Audio Connector Wiring
CAUTION: For unbalanced audio, connect the sleeves to the ground contact.
DO NOT connect the sleeves to the negative (–) contacts.
NOTE: The length of the exposed wires in the stripping process is critical. The ideal
length is 3/16 inches (5 mm). If the exposed section is longer, the exposed
wires may touch, causing a short circuit between them. If it is shorter, the
wires can be easily pulled out, even if tightly fastened by the captive screws.
MTP 15HD A Series • Installation and Operation
11