Extron Electronics MLM 52 VC - Manual (Page 9)

MLM 52 Wall Mounting Kits • Installation 33
Installation
This section describes the installation of the MLM 52 1GWP and MLM 52 VC faceplates.
Topics include:
• Attaching the Controller to the Faceplate
• Installation
Attaching the Controller to the Faceplate
MLM 52 1GWP
1. Remove the three screws (located at the rear of the original faceplate) that hold the
MLC 52 controller in place.
2. Carefully remove the controller from the faceplate.
Faceplate
Standoff
MLC 52
DISPLAY
ON
PC
VIDEO
OFF
VOL
VOL
Use supplied screws.
Figure 3. Removing and Installing an MLM 52 1GWP Faceplate to the MLC 52
Controller
3. With the replacement MLM 52 1GWP faceplate face down, align the MLC 52 (also
face down) over the standoffs on the rear.
4. Secure the controller to the faceplate with the provided screws.
MLM 52 VC
1. Holding the original faceplate face down, remove the screws at the rear that hold the
MLC 52 controller and volume control module in place.
2. Carefully remove the controller and the volume control module from the faceplate.
3. With the replacement MLM 52 VC faceplate face down, align the MLC 52 controller
and volume control modules (also face down) over the standoffs on the rear of the
faceplate.