Extron Electronics MLC 60 Series User Guide - Manual (Page 24)

VOLUME
Extron
DISPLAY
VIDEO
PC
ON OFF
Figure 14. Removing the Faceplate (MLC 60 Series D Models)
2. If you are switching faceplates, transfer the buttons from the faceplate you removed
to the replacement one.
3. Make any desired button changes (see “ Replacing Buttons ,” later in this section).
4. To attach the faceplate, make sure that both the faceplate and the MLC board are
upright and line up the pegs in upper-left and lower-right corners on the back of the
faceplate with the two diagonal holes on the MLC board.
5. Press the faceplate onto the board with the pegs in the holes until the tabs at the top
and bottom of the faceplate snap into their slots on the board (see the illustration
below).
VOLUME
DISPLA
Y
OFF
ON
MUTE
LAPTOP
VIDE
O
PC
Insert peg
on faceplate
into hole.
Peg
Insert peg
on faceplate
into hole.
Insert tab on faceplate
into slot.
Tab
Figure 15. Attaching the Faceplate (MLC 60 Series D Models)
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation 18