Extron Electronics MTP U T A D User Guide - Manual (Page 16)

MTP U T A D • Installation and Operation 10
Rear Panel Features
OUTPUT
1 _ 4 +
12 V
.5A
MAX 3 2
11
12
13
Figure 6. Transmitter Rear Panel Features
k
Output connector — Connect a TP cable from this RJ-45 female connector to the
compatible receiver (see “ TP Cable Termination ” to wire the RJ-45 connectors).
NOTE: See the table on page 3 for recommended transmission ranges.
l
Contact closure controls — To select a video input to output, momentarily tie the
assigned pin for that format to ground.
Pin Format Pin Format Pin Ground
1 Composite 3 YUV 5 Ground
2 S-video 4 PC
NOTE: The front panel Contact DIP switch ( h ) must be on (up) for contact closure
to be available.
m
DC power connector — Plug the external 12 VDC, 1 A power supply into this 2-pole
captive screw connector (see " Power Supply Wiring " to wire the connectors).
NOTE: The remote power capabilities available with certain MTP models are not
supported by this unit; the transmitter and receiver both must be powered.