Extron Electronics SCS 300 User Guide - Manual (Page 12)

2-5 SCS 300 • Installation, Connection, and Settings
Mounting the SCS 300 through a desk desk
To mount the SCS 300 through a desk or table using the through
desk mounting kit (Extron part # 70-077-02, MBD 129), do the
following:
1.
Attach the mounting brackets to the SCS 300 using four
machine screws and washers supplied with the mounting
kit, as shown in figure 2-4.
Figure 2-4 — Attaching the through desk brackets
2. Holding the device up against the underside of the surface
to which you are mounting, mark the four screw holes.
3 . Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" (6.4 mm) deep, where marked on the template.
4. Using the four supplied wood screws, attach the brackets
to the mounting surface (see figure 2-4).
5 . When the SCS 300 is mounted, continue the installation by
connecting the input, output, and power cables.