Extron Electronics SCP 100 Control Pad User Guide - Manual (Page 12)

System 5 cr • SCP 100 User’s Manual • Extron
Reference
Extron’s Comm-Link cable
Comm-Link cable was designed for installations such as the
System 5. You may choose to use this or a similar low-loss cable.
Pin assignments and suggested Wire usage is as follows:
A = Signal without carrier (violet or blue) = 22 AWG
B = Ground (black) = 18 AWG
C = Signal with carrier (white) = 22 AWG
D = Ground (Drain) = 24 AWG
E = +12V (red) = 18 AWG
Figure 2-2. Extron’s Comm-Link cable was designed for use with the SCP 100.
Part Numbers
Comm-Link Cable:Cut lengths Part #
50 feet 26-461-01
100 feet 26-461-02
200 feet 26-461-03
400 feet 26-461-04
Bulk spools:
500 feet 22-119-02
1,000 feet22-119-03
SCP 100 Panels:
Gray 60-239-01
Black 60-239-02
White 60-239-03
Captive Screw Connector:
5-pole, 3.5 mm 10-319-10
(included with each SCP 100)
2-3