Connecting the tlp 710cv, Step 9 - connect the mtp input, C b a – Extron Electronics TLE 710 Setup Guide User Manual

Page 5: Step 9 — connect the mtp input

Advertising
background image

5

Connecting the TLP 710CV

NOTE: The rest of this guide applies only to the TLP 710CV (not to the TLE 710).

The cable connections are located in a panel on the bottom of the TLP 710CV:

POWER

12V

1.0A MAX

LAN / PoE

MTP

c b a

Step 9 — Connect the MTP Input

Connect the output of an Extron Mini Twisted Pair (MTP) transmitter to the MTP socket (

a

) on the TLP 710CV. This signal

provides composite or S-video and audio input.

ATTENTION:

Ensure the MTP transmitter is connected to the MTP socket (

a

, in the figure above). Both the MTP

connector and the LAN and PoE connector use RJ-45 connectors, but the wires on each connector use different voltages.
Inputting the wrong voltages into a socket will damage the TLP 710CV.

Step 10 — Connect the Network and Power Over Ethernet Connector

Extron strongly recommends using a Power over Ethernet (PoE) power supply, although a 12 VDC, 1.0 A power supply (not
provided) can be used instead (see below).

ATTENTION:

•

Before connecting the PoE connector (

b

), read the cautions listed in the “Network and Power over Ethernet

Connector” section of the TLP 710CV User Guide, which is available at www.extron.com.

•

Ensure the network connector is connected to the network socket (b). Both the MTP connector and the LAN and PoE
connector use RJ-45 connectors, but the wires on each connector use different voltages. Inputting the wrong voltages
into a socket will damage the TLP 710CV.

Connecting to the Network Directly (Using an external 12 VDC Power Supply)

If the PoE power supply is not used, run a straight-through cable from the LAN/PoE connection (

b

) to a network switch or router.

Connecting to a Power over Ethernet Power Supply

1.

Use a straight-through LAN cable to connect the LAN-IN socket to a
network switch or router.

2.

Use a second straight-through LAN cable to connect the PWR LAN-OUT
socket to the LAN/PoE connector (

b

) on the TLP 710CV. This cable carries

network information and 48 VDC.

3.

Connect the IEC power cord from the power supply to a convenient
100 VAC to 240 VAC, 50-60 Hz power source.

Step 11 — Connect the External Power Supply (Optional)

CAUTION:

Before connecting the power supply, read the cautions listed in the “Power Connector” section of the

TLP 710CV User Guide, which is available at

www.extron.com

.

Extron strongly recommends using PoE to provide power to the TLP 710CV. To use a 12 VDC, 1.0 A
power supply (not provided), connect the two pole, 3.5 mm captive screw connector from the power
supply (part number 

70-775-01) to the power supply socket on the rear panel (

c

).

NOTE: For advice about using captive screw connections, see the notes in the “Power

Connector” section of the TLP 710CV User Guide, which is available at

www.extron.com

.

Power over Ethernet (PoE) Power Supply

PWR LAN-OUT

LAN-IN

To Network Switch

To TLP 710CV

a

MTP connector

b

LAN and PoE connector

c

External power supply connector

-

POWER

12

V

1.0A MAX

3/16"

(5 mm) Max.

Advertising
This manual is related to the following products: