Control buttons, Control.buttons -4, Preliminar y – Extron Electronics MVX VGA A User Guide User Manual

Page 27: Operation, cont’d

Advertising
background image

Operation, cont’d

MVX VGA A Matrix Switchers • Operation

3-4

PRELIMINAR

Y

Control buttons

d

Enter button and/or LED — The Enter button and LED have three primary

functions (•) and four secondary functions (❏):
• Saves changes that you make on the front panel. To create a simple

configuration:

Specify RGBHV, audio, or both (see I/O selection buttons [

h

] and

[

i

]).

Press the desired input button (

a

).

Press the desired output button(s) (

b

).

Press the Enter button.

• Indicates that a potential tie has been created but not saved.
• Indicates that a global preset has been selected to be saved or recalled but

that the preset action has not been accomplished.

❏

With the Preset, View, and Esc buttons, selects Serial Port Configuration

mode. See “Selecting the rear panel Remote port protocol and baud rate”

on page 3-38.

❏

Selects 9600 baud for the Remote port in Serial Port Configuration mode.

See “Selecting the rear panel Remote port protocol and baud rate” on

page 3-38.

❏

Indicates that the Remote port is set to 9600 baud in Serial Port

Configuration

mode. See “Selecting the rear panel Remote port protocol

and baud rate” on page 3-38.

❏

With the RGBHV and Audio buttons, select front panel security lockout

mode 2 or toggle between mode 0 (unlocked) and mode 2. See “Setting

the front panel locks (Executive modes)” on page 3-36.

e

Preset button and/or LED —

The Preset button and LED have two primary

functions (•) and three secondary functions (❏):

•

Activates Save Preset mode to save a configuration as a preset and Recall

Preset

mode to activate a previously-defined preset.

•

Blinks when Save Preset mode is active and lights steadily when Recall

Preset

mode is active.

❏

With the Enter, View, and Esc buttons, selects Serial Port Configuration

mode. See “Selecting the rear panel Remote port protocol and baud

rate” on page 3-38.

❏

Selects 19200 baud for the Remote port in Serial Port Configuration mode.

See “Selecting the rear panel Remote port protocol and baud rate” on

page 3-38.

❏

Indicates that the Remote port is set to 19200 baud in Serial Port

Configuration

mode. See “Selecting the rear panel Remote port protocol

and baud rate” on page 3-38.

Advertising