I/o controls, I/o.controls, Preliminar y – Extron Electronics MVX Plus 128 VGA A User Guide User Manual

Page 33

Advertising
background image

3-7

MVX Plus 128 VGA A Matrix Switcher • Operation

PRELIMINAR

Y

I/O controls

You must specify video, audio, or both when you are creating or viewing a

configuration. This is done with the RGBHV button (

g

) and Audio (

h

) buttons.

g

RGBHV button — The RGBHV button has two primary functions (•) and six

secondary functions (❏):
• Selects and deselects video for a configuration that is being created or

viewed.

• Lights green to indicate that video is available for configuring or for

viewing.

❏

With the Enter button and Audio button, selects between front panel

locks (Lock mode 2 and Lock mode 0). See “Setting the front panel locks

(Executive modes)” on page 3-41.

❏

With the Audio button, selects between front panel locks (Lock mode 2

and Lock mode 1). See “Setting the front panel locks (Executive modes)”

on page 3-41.

❏

With the Audio button, commands the front panel system reset.

See “Performing a system reset from the front panel” on page 3-42.

❏

Selects the RGB delay mode, in which you can set the RGB delay.

See “Setting RGB delay” on page 3-23.

❏

Select the RS-232 protocol for the RS-232/RS-422 port in Serial Port

Configuration

mode. See “Selecting the rear panel Remote port protocol

and baud rate” on page 3-43.

❏

Indicate that the RS-232/RS-422 port is set to the RS-232 protocol in

Serial Port Configuration

mode. See “Selecting the rear panel Remote port

protocol and baud rate” on page 3-43.

h

Audio button — The Audio button has two primary functions (•) and six

secondary functions (❏):
• Selects and deselects audio for a configuration that is being created or

viewed.

• Lights to indicate that audio is available for configuration or viewing.

❏

Selects the Audio mode, in which you can adjust the input audio level and

the output audio volume. See “Viewing and adjusting the input audio

level” on page 3-32 and “Viewing and adjusting the output volume” on

page 3-36.

❏

With the Enter button and RGBHV button, selects between front panel

locks (Lock mode 2 and Lock mode 0). See “Setting the front panel locks

(Executive modes)” on page 3-41.

❏

With the RGBHV button, selects between front panel locks (Lock mode 2

and Lock mode 1). See “Setting the front panel locks (Executive modes)”

on page 3-41.

❏

With the RGBHV button, commands the front panel system reset.

See “Performing a system reset from the front panel” on page 3-42.

❏

Select the RS-422 protocol for the RS-232/RS-422 port in Serial Port

Configuration

mode. See “Selecting the rear panel Remote port protocol

and baud rate” on page 3-43.

❏

Indicate that the RS-232/RS-422 port is set to the RS-422 protocol in

Serial Port Configuration

mode. See “Selecting the rear panel Remote port

protocol and baud rate” on page 3-43.

Advertising