Configuration, Internal configuration – Extron Electronics RGB 203 Rxi User Guide User Manual
Page 12
Configuration
This section of the user guide provides information about
of
jumpers on the circuit boards and
configuration of the rear panel DIP switches
Internal Configuration
The interface is factory configured to output RGBHV or RGBS video with sync that follows
the input and is clamped to the back porch. The interface can be configured to output
positive or negative sync or to clamp on the sync tip. These reconfigurations all require the
interface to be opened.
1.
Remove the three screws on each side and the two screws on top of the cover (see
figure 6).
RGB 203xi
BOOST
LEVEL
CONTR
OL
PEAK
INPUT
1
2
3
WITH ADSP
TM
CENTERING
Remove (6)
Screws
Slide cover back slightly,
then lift straight up.
Figure 6.
Removing RGB 203 Rxi Cover
CAUTION: Before removing the cover, take steps to prevent electrostatic discharge,
which can damage the circuit boards of the unit.
2.
Lift the cover off by sliding it straight back slightly and then lifting it straight up.
RGB 203 Rxi • Configuration
6