Extron Electronics ES3610_11 User Guide - Manual (Page 32)

Section 3: VN-GLIMPSE Setup Utility ES3610/11 User Guide
Page 32 I447GB issue 6
Click OK to continue. The following dialog will now appear:
To reboot the RGB ADAPTER and implement the new settings now, click Yes.
Otherwise, click No — the settings will be implemented the next time that the RGB ADAPTER is
rebooted.
To change Encoder Parameters (Stream Settings)…
Click the Stream Settings button.
The Set Stream Settings dialog will appear:
To change the maximum refresh rate, adjust the Frames/Sec value.
To change the maximum bandwidth available to the RGB ADPATER, set the Bandwidth Limit
value as required.
HINT: For advice about using these parameters, see ‘Understanding VN-GLIMPSE Performance’
(pages 56-58).
To check the current Firmware Version…
Click the Version button.
The Version Information dialog will appear: