Extron Electronics SW DVI A Series User Guide - Manual (Page 14)

SW DVI A Series • Installation
Installation, cont’d
2-14
SW DVI A Series To enable autoswitching,
1
. Cut a small piece of wire to use as a jumper.
2 . Insert the ends of the wire into pin holes 4
and 5 of the provided 5-pole captive screw
plug, connecting pins 4 and 5 together. (See
the figure at right.)
3 . Use an Extron Tweeker or other small
screwdriver to tighten the plug’s two screws
above pin slots 4 and 5, so that the jumper
wire ends remain securely in place.
4 . Insert the plug into the 5-pole captive screw
connector on the SW2/SW4 rear panel.
0.4A MA
X
12V
POWE
R
+
INPU
TS
INPU
TS
OUTPU
T
1
1 OUTPU
T
REMOTE / AUTO
- SW
2
3
2
4
Remote/Auto-Sw connector with pins 4 and 5
connected by a jumper
Autoswitching remains in effect as long as the jumper wires are
connecting the two pins together.
3
Chapter Three
Operation
Front Panel Features
Operations
Updating Firmware