Installation and operation, Vsw i aap interface, Front panel features – Extron Electronics VSW I AAP Installation User Manual

Page 2

Advertising
background image

1

VSW I AAP • Installation and Operation

Installation and Operation

VSW I AAP Interface

The VSW I AAP passive interface features a computer video input and

pass-through, an unbalanced stereo input and pass-through, and an

input select (Show Me) button. All VGA, audio, and control signals are

carried from the rear panel of the AAP to the switcher via a single Extron

VGA/audio cable assembly.

Front panel features

VSW I AAP

COMPUTER

AUDIO

SHOW ME

1

3

2

Figure 1 — Front panel features

a

Computer video input — Input VGA-UXGA, RGBHV, RGBS,

RGsB, RsGsBs, component video, or HDTV component video

through this 15-pin female VGA connector.

b

Audio input — Input unbalanced stereo

audio through this 3.5 mm mini audio

jack. See the diagram at right.

c

Input select (Show Me) button —

Pressing this button tells the connected

and compatible switcher to select this

AAP as the switcher's active input.

See "Rear panel features" on the following page.

N

The connected switcher must be compatible with this VGA

pin 5 pull-up control feature. The Extron VSW 2VGA A and

SW VGArs series switchers are compatible with this feature.

Check the user's manuals for these switchers for more detail.

N

The show me feature will not work when connected to

SW VGArs series switchers with a circuit board part number of

20-527-0

x or 20-935-0x.

N

Use of the show me feature with specific switchers requires

that jumpers be set in the VSW I AAP. See “Setting

VSW I AAP Jumpers” on page 4.

Sleeve ( )

Ring (R)

Tip (L)

3.5 mm Stereo Plug Connector

(unbalanced)

Advertising