Gotham PDRDF – Semi-recessed Dish_Glass - Manual (Page 2)

SAVE THESE INSTRUCTIONS
Figure 11
CJ5201101 Rev. A
4/11 2 of 2
©2011 Acuity Brands Lighting, Inc.
All Rights Reserved.
Figure 10 Figure 9
Figure 12 Figure 13
Non-Flexible Wiring Method
If non-flexible wiring method is used, follow procedure for
flexible wiring method. Then lower mounting frame equal
to the thickness of the finished ceiling or slightly above as
shown in Figure 7.
3. If additional security is required, a No. 8 sheet metal
screw, wire tie or wire (not supplied) may be used to tie the
latch arm to the mounting frame as shown in Figure 5.
4. Remove knockouts on junction box to feed power supply
to fixture as shown in Figure 8. Supply wire must meet
applicable electrical codes and be rated for a minimum
90°C. Junction box is thru-wire rated for 8-No. 12 AWG
conductors (4 in – 4 out).
5. Complete necessary wiring connections and snap door
onto junction box as shown in Figure 8.
6. After ceiling has been installed and finished, refer to steps
9 – 12 on sheet 1 for final installation.
Clamping
Latch Arms
Closed
Open
Figure 5
Figure 8
Junction Box
Figure 7
Figure 6
Ceiling
Mounting
Frame
Dish
Bent Tab
T-Bar
Wire Tie
Channel
Bar