Imetec BELLISSIMA MULTICURL S1 700 - Manual (Page 15)

13
simply by scrolling the selector (4).
• take a lock of hair, which is not too wide or voluminous
between the fingers (about 2 cm), using smaller locks of
hair it is possible to obtain more defined curls.
• Keeping the hair lock tightly, bring the cold tip (1) of the
heated parts just above the place where the hands are
holding it and proceed by inserting the lock of hair into
the heated part slot (2) making sure that it almost reaches
the bottom of the slot; next move up along the hair lock
and come in proximity of the roots and maintain styler
position.
• slightly tilt the product compared to the hair lock,
rotate the instrument 360° in one or the other direction
depending on the direction of the effect to be created.
Do not roll the hair lock any more, but allow the product
to slowly slide downwards, maintaining its inclination so
that the hair lock does no overlap on itself during the
movement.
• if desiring a more sustained curl, proceed very slowly and
add additional rotations that will help the hair lock adhere
better to the heated parts (2).
in order to discover the numerous methods and
effects that can be achieved using the styler, consult
the styling Guide.
• once styling operations have terminated, shut off the
appliance by sliding the on/off selector switch le(5)
to oFF position, disconnect the power supply cable
from the socket (7) and let the instrument cool down
completely before putting it away.
note:
it is possible that steam develops during straightening;
this is excess humidity in the hair that evaporates.
Make sure that the tip of the hair lock is always positioned
in the lower area of the barrel in order to improve
smoothness and lock release.
cleaninG
• Disconnect the appliance from the power mains (7)
• verify that the hair styler is cold
• clean the external and internal surfaces of the heated
parts (2) and the handle of the styler using a soft and
damp cloth. in order to clean the internal surface,
delicately insert a cloth in the slot of the cylinder and
en
MI000475.indd 13 01/03/11 20.53