Imetec COMPACT SUPERPLATE - Manual (Page 12)

10
GB
Polishing function
Switch the polishing function on by setting the ON/OFF switch (5) to position I [Fig. E1]. To switch the
function off, set the ON/OFF switch (5) to position 0.
Vacuum cleaner function
Switch off the appliance and remove the polishing head (11) by pressing the polishing head release button
(10). Install the combined brush, and turn
on the vacuum cleaner function by setting the ON/OFF switch (5)
to position II.
After fi nishing your work, switch off the appliance by setting the ON/OFF switch (5) to position 0 and pull the
power plug out of the socket.
Rewind the main power cable (7) on the winding hooks (6).
MAINTENANCE
Before opening the appliance, switch it off and pull the power plug from the socket! Before using the
appliance again, make certain that all parts cleaned with liquid are completely dry!
Cleaning the appliance:
Clean the appliance as needed with a damp cloth. Do not use solvents or other aggressive or sharp-edged
cleaning aids. These could damage the surface.
Cleaning the brush set (12):
You can wash the brush set (12) with warm water using a neutral detergent. The felt (12A) and wool felt
brushes (12D) can be cleaned by rubbing them gently with a damp cloth. Let the brush set (12) dry thoroughly,
making sure that they stay in horizontal position.
Cleaning the combination brush (13):
With the motor switched on, run your hand over the brush to loosen clinging dust and lint which will be
directly vacuum cleaned.
Cleaning the dust collection system (9):
Remove the collected dust from the appliance when the vacuum cleaner suction power is decreased. The
dust container can be fi lled up to the marking (9F) indicated in the dust collection system (9).
Note:
It is strongly recommended that the dust collection system (9) is emptied and the fi lters cleaned after
every use.
If the power of your vacuum does not improve after cleaning the dust collection system (9), this could result
from the fi lters in the appliance being very dirty. In this case, the fi lters must be replaced. To do so, follow the
instructions on the image symbol .