Imetec SENSUIJ SM2-200 - Manual (Page 48)

43
DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (fig. A)
1. removable pillow
2. back rotating massaging heads
3. securing straps
4. connectors
5. mains power supply with connector
6. control
7. control sleeve pocket
ASSEMBLY/PREPARATION
• Unpack the product and remove the stops used for transport.
• Check that it is integral and undamaged.
• The massager is supplied with Velcro securing straps making it possible to adapt it to the majority
of chairs available on the market. Pass the two straps (3) behind the chair back and secure them to
each other using the Velcro. If you prefer, simply rest the massager on your chair or armchair. Do
not use it on wooden surfaces as they may be damaged.
ATTENTION!
The massager is unsuitable for use in a car.
• Connect the transformer to the massager via the specific connectors (4).
• Connect the product to the domestic mains.
USE
• Press the POWER button once to turn the massager on.
• Press the
key for a massage with clockwise movement.
• Or else press the
key for a massage with anti-clockwise movement.
• Press the EXTRA SOFT" button if wanting a soft and slow moving massage.
• Press the SOFT button if wanting a massage with greater intensity.
HEAT : heating function.
• Press the HEAT button to activate heat during the massage.
• Press it again to deactivate it.
VIBRATING : vibrating massage buttock area
Press the VIBRATING button to activate the vibrating massage in the sitting area. The seat will vibrate
at minimum level and the LED next to the letter (L) Low vibrating level will switch-on. To increase
intensity to (M) Medium vibrating level, press the key again, the corresponding LED will switch-on.
Finally, to pass to (H) High vibrating level, press the key again.
To deactivate the massage press the VIBRATING key after the (H) High level again.
• Press POWER again to turn the massager off.
Remove the pillow if wanting a more intense massage.
If wanting a more delicate massage, use a towel as well as the pillow.
EN