Ultimate Support TS-99BL - Manual (Page 2)

2
set-up special
instructions
lighting tree
1
2
3
STEP 5
Line up arrow TeleLock® collar with “RAISE”. Then raise center tube
6-10”. Put speaker cabinet on top of the stand and raise the cabinet
to desired height. Set to “LOCK” position.
STEP 6
To lower speakers, SLOWLY rotate arrow on TeleLock collar to
“LOWER” position until speaker starts to lower. To slow descent,
turn collar toward the “RAISE” position. When ready to remove the
speaker, rotate collar to “LOCKED” position.
On TS-99BL Leveling Leg Stand, 3rd leg adjusts to level stand on uneven
surfaces. Untighten leg telescoping collar, lengthen leg and retighten knob.
1. Occasionally clean the stand with a damp
cloth or non-abrasive cleaner.
2. When loading the stand, ONLY add the
speaker when the stand is in a fully upright
position (all legs on the floor).
3. Do not drag the stand while it is loaded;
this could break the fittings and result in
damage to the stand which will not be
covered under warranty.
4. Check that the leg collar is securely locked
when supporting equipment.
5. Always release the TeleLock collar with
caution and stand clear of the load.
6. The stand is equipped with a tube lock
which prevents accidentally pulling out the
center tube.
STEP 1
Open leg fitting lock lever.
STEP 2
Turn stand upside down and pivot legs so Ultimate Support label
faces you.
STEP 3
Turn stand upright and slide leg fitting to adjust diameter of leg
spread. Leg braces should be parallel to floor for maximum stability.
Close lock lever.
STEP 4
The built-in adapter fits both 1-1/2” or 1-3/8” internal diameter speaker
sockets. Use the lower position for 1-1/2”. For 1-3/8” sockets, depress
push buttons and raise adapter until it locks in raised
position.
4
5
6
Turn a Tall TS-99B, or TS-99BL Speaker
Stand into a Lighting Tree.
For a Single-Tier Lighting Tree add:
LTB-48B (#14107)
48” Lighting Crossbar
For a Two-Tier Lighting Tree add:
LTV-24B (#14108) 24” Vertical Extension
LTB-48B (#14107) 48” Lighting Crossbar
LTB-24B (#14106) 24” Lighting Crossbar Pair
3
accessories
Zippered Tote Bags
Speaker Stand
Mounting Bracket
Speaker Stand Socket
Mounting Bracket
BMB-200K (#10766)
External bracket securely mounts any
speaker cabinet with a flat bottom on
an Ultimate Support speaker stand.
TSM-150MK (#13421)
TSM-138MK (#13425)
Internal metal bracket securely mounts
any speaker cabinet with a flat bottom
on an Ultimate Support speaker stand.
Heavy-duty, padded, zippered
Tote Bags
BAG-90 (#15691)
Holds one TS-90B Speaker Stand.
10.5” x 49.5” (267 mm x 1257 mm)
BAG-90D (#15693)
Holds two TS-90B Speaker Stands.
14.5” x 49.5” (368 mm x 1257 mm)
BAG-99 (#15692)
Holds one
TS-99B/TS-99BL Speaker Stand.
10.5” x 60.5” (267 mm x 1537 mm)
BAG-99D (#15694)
Holds two
TS-99B/TS-99BL Speaker Stands.
14.5” x 60.5” (368 mm x 1537 mm)