Braun 3710 InterFace Excel - Manual (Page 7)

7
3 Keeping your shaver in top shape
3.1 Cleaning
• After shaving, switch the shaver off. Press the release buttons, take off the
shaver foil (d) and gently tap it out on a flat surface (e).
• Then thoroughly clean the cutter block with the brush (f). About every four
weeks, clean the cutter block with Braun cleaning agents (g).
• Do not clean the shaver foil with the brush.
• If you have a very dry skin and you notice a reduced operation time of the
shaver, you should put a drop of light machine oil onto the InterFace trimmer
and shaver foil (g).
3.2 Replacing the shaving parts
• To maintain 100% shaving performance, replace your foil and cutter block at
least every 18 months or when worn. Change both parts at the same time for
a closer shave with less skin irritation.
(Shaver foil and cutter block: part no. 3000)
• Press the release buttons, take off the shaver foil. Replace the new shaver foil
in the right direction until it locks in place.
• To remove the cutter block, lift it off (g).
• To replace the cutter block, snap onto the holding studs.
Subject to change without notice.
This product conforms to the European Directives EMC 89/336/EEC
and Low Voltage 73/23/EEC.
Please do not dispose of the product in the household waste at the end
of its useful life. Disposal can take place at a Braun Service Centre or
at appropriate collection points provided in your country.
5449310_F3710_S4_42 Seite 7 Montag, 22. August 2005 11:38 11