NZXT Sentry LXE - Manual (Page 2)

2
Installation
Thank you for purchasing an NZXT product.
1. Open the side panel to your computer chassis and screw the temperature controller into a free PCI slot
2. Connect the power cable to the controller board and the molex to the power supply.
3. Connect the 3pin fan connectors to the board and fans you want to control and detect.
4. Connect the fan probes to the board insuring the red line is aligned to the left side. Tape the probes to the areas
to detect temperatures (Recommended is CPU, GPU and Hard drive locations).
5. Insert the battery into the controller board.
6. Finally, using the cable connected, connect the board to the external display.
7. Power on your PC to begin usage.