Andrew James AJ000127 Double Induction Hob User Manual
Page 8
8
the ceramic field as this could lead to the surface becoming scratched.
Make sure that the device is properly cleaned before storing it in a dry
place.
Electronic control of low voltage (<160V) Make sure the appliance is connected to
the voltage indicated on the rating label.
Electronic control of excess voltage
(<270V)
Make sure the appliance is connected to
the voltage indicated on the rating label.
IGBT open or short circuit
Please send back to customer service
Overheating protection on power mode
(>150˚C)
Eliminate the course of overheating.
Once the cooktop has cooled, the
appliance can be put into operation
Temperature sensor open or short
circuit
The temperature sensor underneath the
glass ceramic plate is defective. Please
send back to customer service.
Overheating protection on TEMP. mode
(>240˚C)
Eliminate the course of overheating.
Once the cooktop has cooled, the
appliance can be put into operation
again
Temperature sensor malfunction
Please send back to customer service.
LED flashing “L” then power switching
off
Test that the cookware you are using is
induction compatible. If the cookware is
compatible contact customer services.
Troubleshooting
Problem
Solution