Kendall Howard 5500-3-100-36 36 Training Table Cable Management Enclosure - Manual

4
DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com-
plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The information
herein does not provide for every possible contingency in connection with the installation
or use of the product(s). The information contained in this document is subject to change
without notice or obligation. Kendall Howard LLC assumes no responsibility for the
accuracy, completeness or reliability of the information contained in this document. Any
reliance placed on the information is therefore strictly at your own risk.
For details about product warranty, please visit www.kendallhoward.com
Assembly - Step 4:
.
a. Secure female Hinges to the Cable Enclosure Bottom with the
M5x10 Screws. Make sure the hole openings are face to-
wards each other.
b. Secure 1 Male Hinge to Cable Enclosure Door Bottom with
the M5x10 Screws. Insert should be facing to the outsides of
the door
c. Insert the installed male hinge into the female hinge. Take
the remaining male hinge and insert into the opposing female
hinge and secure to the door with the M5x10 Screws
Instructions / Directions
Training Table Cable Management Enclosure
# 5500-3-100-36
1
I N N O V A T O R S I N P R O D U C T D E S I G N
w w w . k e n d a l l h o w a r d . c o m
A d d r e s s : 1 0 1 5 2 L i b e r t y L a n e
C h i s a g o C i t y , M i n n e s o t a , 5 5 0 1 3
U n i t e d S t a t e s o f A m e r i c a
P h o n e : 6 5 1 - 2 1 3 - 1 3 3 3
F a x : 8 0 0 - 4 1 8 - 6 8 9 7