SM Pro Audio M-Patch 2: Passive Stereo Controller/Switch Box User Manual
Page 7
7
4.3 Analog Audio Outputs
The M-Patch 2 features two (2) pairs (L&R) of XLR balanced analog output con-
nectors on the rear panel. These are labeled “1” & “2”.
Connect these outputs to your destination device (active monitors, digital recorder,
or wherever you need the attenuated output signal sent).
* Note: It is possible to activate or deactivate each desired output pair via the ‚out-
put selector switches‘ on the front panel. It is possible to have both 1&2 outputs
active at the same time. This is very useful when connecting the outputs to a re-
cording device and a monitoring device simultaneously!
4.4 Power Connection
Power to the M-Patch 2 is required only if you wish to use the headpho-
ne amplifier, or view the illuminated led indicator lamps.
The included power supply can be connected from mains power to the
power connector socket located on the rear panel of the M-Patch 2.
The Blue led on the front panel (next to the mono/stereo control switch) will illumi-
nate when the external power supply is connected and mains power is present.
* Note: All passive attenuation functions operate fully without the connection of the
power supply. This enables full portable use of the M-Patch 2 without restriction.