Cla-Val X144 Technical Manual - Manual (Page 20)

SECTION 3: X144 e-FlowMeter Operation
3.2 – Stopping Operation / Removal of X144 e-FlowMeter
d) Slide Insertion Tool straight out, then rotate 180 degrees so that the bevel is facing upstream of the
valve, which is now facing the same direction of the centering groove, as shown below.
e) The lip of the Insertion Tool will engage the inside of the Measurement Cylinder, as shown below.
f) Once engaged, use light force to straighten the measurement cylinder, and then lock the insertion
tool in place with the Insertion Tool lock, as shown below.
4) Re-install the pipe plug into the open boss of the valve.
pull out tool and
rotate 180 °
centering
groove
upstream direction,
same side as groove
Insertion Tool lip
inside of
Measurement Cylinder
Figure 3-4
Figure 3-5
Figure 3-6
17